Drill Press Safe Work Procedure

PRE-Operation:

Task (Drawings, instructions, Specifications, Material… etc.) is clearly understood.
Identify ON/OFF switch and emergency stop button and test any interlocking devices (if applicable).
Make sure the machine is turned off or the emergency stop switch is engaged, before comment of any work or inspection.
Ensure chuck guards is in place.
Ensure work piece is securely fastened to the work table.
Ensure the drill bit or cutting tool is locked securely in the chuck.
Remove the chuck key immediately after securing the drill bit or cutting tool.
Adjust speed and feed to suit the drill diameter and the material of the work.
Ensure the drill bits are sharp, in good condition and secured.
Faulty equipment must not be used and must be immediately reported to the shop technician.

Never leave the Drill Press running while unattended.
Switch off the drill press and ensure it has come to a complete standstill before making any adjustments or cleaning swarf accumulations/ debris.
Lubricate drill bit when drilling metal.
Reduce the drilling pressure/feed when the drill begins to break through the work piece. This action prevents drill from pulling into the work and breaking.
Do not force the drill with extra pressure.
Do not hold work by hand when drilling holes; secure the work with clamps or vices.
Do not stop rotation of chuck and spindle with your hand

Switch off the machine and reset all guards to a fully closed position.
Allow all part to come to stop before making alterations or at completion of work.
Remove drill bit from chuck and remove chuck key.
Leave the machine in a safe, clean and tidy state.
Leave the working area clean and tidy.