Lathe Machine Safe Work Procedure

Personal Protective Equipment (PPE) Required

Safe Work Procedure Checklist

Task (Drawings, instructions, Specifications, Material… etc.) is clearly understood.
Identify ON/OFF switch and emergency stop button and test any interlocking devices (if applicable).
Make sure the machine is turned off or the emergency stop switch is engaged, before comment
of any work or inspection.
Ensure all security guards including the chuck and tool post guards are in place.
Ensure the work piece has been suitably prepared for the lathe operation.
Ensure work piece is securely fastened to face plate, chuck or between centres as required by the task.
Remove the chuck wrench/key immediately after adjusting the chuck.
Rotate the work piece by hand to check clearance between tool rest and bed.
Adjust speed and feed to suit the diameter and the material of the work and turning operation.
Ensure the cutting tools are sharp, in good condition and secured.
Test the cooling fluid system operation and availability.
Faulty equipment must not be used and must be immediately reported to the shop technician.

Never leave the machine running while unattended.
Switch off the lathe and ensure it has come to a complete standstill before making any adjustments.
Keep the tool rest adjusted close to the work and at the correct height.
Adjust speed to suit the diameter of the work and turning operation.
Never use the file to smooth, clean or deburr a work piece.

Switch off the machine and reset all guards to a fully closed position.
Allow all part to come to stop before making alterations or at completion of work.
Remove work from chuck and remove chuck key.
Leave the machine in a safe, clean and tidy state.
Leave the working area clean and tidy.